Rocktron X-Tune Manuel d'utilisateur télécharger pdf (Page 13)

Tuning Instuctions

Step 1 - plug the guitar/bass into the tuner - see “connections” section.

Step 2 - play a note on your guitar. In the example on the following page we are

tuning the low E string on a guitar or bass. Pluck your E string, and if needed,

adjust your tuning machine on your instrument until the LED under note “E” is lit

(indicated as 1 in the preceding diagram).

Step 3 - if your note is flat - the “FLAT” LED will light and flash. The speed of the

flash will show you by “how much” your string is flat. If the Flat LED is flashing

rapidly, tune your string up. During this process the LED will begin flashing

slower. (Indicated as point 2 in the preceding diagram).

Step 4 - if your note is sharp - the “SHARP” LED will light and flash. The speed of

the flash will show you by “how much” your string is sharp. If the Sharp LED is

flashing rapidly, tune your string down. During this process the LED will begin

flashing slower. (Indicated as point 3 in the preceding diagram).

Step 5 - Continue with step 3 or step 4 until the flat or sharp LED stops flashing and

the blue “IN TUNE” LED lights. At this point the string is in tune.

Step 6 - Continue steps 2-5 but using your other strings on your guitar or bass.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 19 20

Pas de commentaire

Rocktron X-Tune Manuel d'utilisateur Page 13