Rocktron MicroHUSH Manuel d'utilisateur télécharger pdf (Page 6)

Descriptions continued.........

THRESHOLD Control - This control determines level of attack to cause the HUSH to

activate. Attack is measured in time. Threshold is measured in dB or by the voltage/level of

the signal.

9VDC Power Jack - The MicroHUSH requires 9VDC power to operate (not included/sold

separately). This 2.1mm power jack (Negative Tip/Positive Barrel) provides 9VDC power

to the pedal. We recommend the Rocktron DC OnTap Univeral 9V power supply. More

information on the DC OnTap Line of power supplies at the end of this manual.

ON/OFF Led - This LED shows if the pedal is on or off. When the LED is lit the pedal is

on. When the LED is not lit the pedal is off.

INPUT Jack - Using a standard 1/4” guitar cable, plug the cable from the output of the noisy

pedal into this jack.

FOOTSWITCH - Use this switch to turn on or off the pedal. The On/Off Led will show you

if the pedal is on or off.

OUTPUT Jack - Using a standard 1/4” guitar cable you can plug in another pedal from this

jack or plug directly into your amplier.

1 2 3 4 5 6 7 8 9 10 11 12

Pas de commentaire

Rocktron MicroHUSH Manuel d'utilisateur Page 6