Rocktron Unity Tuner Instructions d'exploitation télécharger pdf (Page 90)

To reload user data from a sequencer

———————————————————————————————————————————————————

1 Connect a standard MIDI cable from the MIDI OUT of the transmitting

sequencer to the MIDI IN of the receiving Prophesy, as shown below.

Important

Do not allow a looping

connection from the MIDI

OUT/THRU of the receiving

Prophesy back to the MIDI

IN of the transmitting

sequencer when performing

a preset dump. Only use the

connections shown at right

when dumping data from one

Prophesy to another.

———————

When dumping data to and

from the Prophesy, always

perform the dump in real

time sequence mode. This

will ensure that data loaded

back into the Prophesy is not

sent faster than the Prophesy

can receive it.

———————

Also, make sure that the

sequencer's MIDI filter is

configured to accept SYSX

information.

———————————————————————————————————————————————————

2 Play back the data stored on the sequencer. The Prophesy will auto-

matically begin storing the information as it is sent from the sequencer,

and will display the data strings as it is storing them. After all the data

has been loaded, the Prophesy will display "LOAD COMPLETE".

———————————————————————————————————————————————————

PLAY

PRESET UTILITY

LOAD COMPLETE

1 2 ... 85 86 87 88 89 90 91 92 93 94 95 96

Pas de commentaire

Rocktron Unity Tuner Instructions d'exploitation Page 90