Rocktron MIDI Mate Manuel d'utilisateur télécharger pdf (Page 24)

Controller Assignment Editing

Enter the editing mode by pressing the 2ND button so that the 2ND

LED lights in any access mode. Then press the EDIT FUNCTION SELECT

"ß" button twice or until "Controller Assignment" scrolls across the

display. Allow the scrolling to finish to enter the Controller Assignment edit

mode. Once the scrolling has finished, "PEDL" will appear. (This is an

abbreviation for "pedal".) In this editing section, the pedal and buttons 5-9

may be assigned a controller number. The pedal should be assigned the

controller number that matches the number of the parameter that the pedal is

to control. For example, the Rocktron ProGAP™'s output level may be

mapped to controller number 8. By assigning the MIDI Mate™'s pedal to

controller 8, the ProGAP™'s output level is now controlled by the MIDI

Mate™'s pedal.

The MIDI Mate™'s pedal may be assigned a different control number

for each preset. In this way you can control the output level parameter in

preset 1, control the treble parameter in preset 2, and control the bass and

gain parameters in preset 4 - just by matching control numbers to the param-

eters you wish to adjust

Buttons 5-9 on the MIDI Mate™ may also be assigned a control

number. These numbers should match a MIDI device's on/off or in/out

parameters. Another example using the Rocktron ProGAP™ would be to

assign the ProGap™'s loop function to control number 9, and assign button 5

(abbreviated as "BTN5") on the MIDI Mate™ to control number 9. Now by

pressing button 5 on the MIDI Mate™ while in the controller access mode,

the ProGap™'s loop would switch in and out with the MlDI Mate™ display-

ing the current status of the loop by the LED over button 5.

The control numbers for the MIDI Mate™ buttons are not assignable

for each preset. Using the example above of button 5 on the MIDI Mate™

being assigned to control number 9, regardless of what preset the MIDI

Mate™ changes to, button 5 is still assigned to control number 9 each time

the MIDI Mate™ changes presets. The last stored status of each assigned

button is also sent on the corresponding controller MIDI channel.

The MIDI Mate™ is shipped from the factory with all the button

control numbers set to "OFF". The pedal control number is set to "OFF" for

each preset on the MIDI Mate™. If a button's control status for a particular

preset should be "ON", then that status must be stored "ON" for that preset,

and for every preset the control is desired "ON".

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 30 31 32

Pas de commentaire

Rocktron MIDI Mate Manuel d'utilisateur Page 24