Rocktron Xpression Manuel de service télécharger pdf (Page 48)

Operating the Xpression

™

Step 8

Step 9

Use the PARAMETER ADJUST control to choose the highest value that the parameter is not

to exceed through MIDI control changes.

Turn the PARAMETER SELECT control one step clockwise to display the Upper Limit

parameter (for PA-A).

ULIM A -2

ULIM A XXX

Note: The Xpression

™

allows you to select an upper and lower value limit which the

parameter cannot exceed. For example, if a parameter has a value range from -

∞

to 0dB, yet you would like the range of the parameter to vary from only -12dB to -

2dB, you may set a lower limit of -12 and an upper limit of -2 via the Upper and

Lower Limit parameters. When a parameter is stored in the Controller Assign

function (Step 7), the maximum parameter value is automatically stored as the

upper limit, while the minimum value is stored as the lower limit.

Step 10

Step 11

LLIM A -

∞

Turn the PARAMETER SELECT control one step clockwise to access the Lower Limit

parameter (for PA-A).

After selecting a value for the upper limit, press the STORE button to save it. "STORED" will

flash briefly on the display.

STORED

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 75 76

Pas de commentaire

Rocktron Xpression Manuel de service Page 48