Rocktron Xpression Manuel de service télécharger pdf (Page 49)

Operating the Xpression

™

Step 12

Step 13

Use the PARAMETER ADJUST control to select the lowest value which the parameter is not

to fall below through MIDI control changes.

Selecting a lower limit value that is greater than the upper limit value will invert the response

of the controller - i.e. the toe position of the expression controller will provide the minimum

value, while the heel position will provide the maximum value.

Note: Steps 1-13 can be repeated nine times for a total of 10 controllers. To exit Con-

troller Assign at any time, turn either the PRESET or FUNCTION SELECT

control. Only those changes that have been stored will be saved after exiting the

Controller Assign function.

After selecting a value for the lower limit, press the STORE button to save it. "STORED" will

flash briefly on the display.

LLIM A -12

STORED

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 75 76

Pas de commentaire

Rocktron Xpression Manuel de service Page 49